$2.99 USD. SKU FTW-ACC-PRT. In stock.
The Prop Tool is designed specifically for removing Hopper® propellers without bending blades or damaging motor shafts. A single motion lifts props off cleanly. Critical for classroom workflows where students swap props between flights. Included with every Hopper® and in the Tool Kit.
Designed and assembled in San Diego, California. NDAA Section 889 compliant. Purchase orders accepted.
Select a color for the face mask and propeller guards
Hopper Firmware 2.0 is here. A brand new sensor fusion and flight stability algorithm delivers decisively better flight.
Hopper holds position better, responds more precisely, and handles rough landings without drama. Crash detection was rebuilt, so a normal landing no longer leaves the drone unable to take off again.
Every Hopper gets it. Free. It loads onto drones already in the field through the FTW Fly app in a few minutes. Nothing to buy, nothing to ship back, no new hardware.
That is possible because FTW owns its entire flight control and telemetry stack. American built, wholly owned, zero outside dependency. When the software gets better, the drones already in your classroom get better with it.
Watch the walkthrough, then open FTW Fly and update yours.