$19.99 USD. SKU FTW-HOP-MTA. In stock.
A pre-tested matched pair of Motor A replacements for Hopper®. Hopper uses two Motor A and two Motor C units arranged for balanced lift. Each pair is individually tested for consistent RPM and torque before packaging, so classroom swaps deliver predictable flight performance. Replace in pairs when swapping, even if only one motor is showing wear, to keep lift balanced across the airframe.
Designed and assembled in San Diego, California. NDAA Section 889 compliant. Purchase orders accepted.
Select a color for the face mask and propeller guards
Hopper Firmware 2.0 is here. A brand new sensor fusion and flight stability algorithm delivers decisively better flight.
Hopper holds position better, responds more precisely, and handles rough landings without drama. Crash detection was rebuilt, so a normal landing no longer leaves the drone unable to take off again.
Every Hopper gets it. Free. It loads onto drones already in the field through the FTW Fly app in a few minutes. Nothing to buy, nothing to ship back, no new hardware.
That is possible because FTW owns its entire flight control and telemetry stack. American built, wholly owned, zero outside dependency. When the software gets better, the drones already in your classroom get better with it.
Watch the walkthrough, then open FTW Fly and update yours.